Gullco's Welding Positioner is a positive drive rotary turn table complete with mounting flange, drive and tilt mechanism and Microprocessor based pulse width modulation motor control. Standard and Programmable models are available. The welding positioner is driven by a low voltage permanent magnet motor and gearhead power unit assembly. The microprocessor motor control enables operator interface of start,stop, clockwise rotation, neutral, counter clock-wise rotation and infinitely variable control of the speed, within the range of the positioner model.
The weld positioners rotation speed is electronically controlled using an optical tachometer located on the back of the gear-motor. Speeds within the range of the model are infinitely variable in both clockwise and counter-clockwise directions through a rotary speed adjustment potentiometer located on the remote control. Table tilt is manually set at any desired angle, from 0º through 90º, quickly and easily. Safety while using the positioner is greatly enhanced with Gullco's low voltage (24 V) control and power supply system.
Standard remote control (Included) - infinitely variable rotation speed within the model's speed range - forward/neutral/reverse switch - run/stop switch - speed potentiometer
Purge-Equipped Models Available
Purge equipped models have a 1/4” (6.4 mm) hole through the centre of the table drive shaft and a gas rotary coupling mounted on the underside of the table ... the shaft having a 1/4” NTP tapped gas inlet hole.